Big cloud siphon mod
I really enjoy this mod and as I’m still new to vaping (less than 2 months in) this mod is used for my first RDA build
Here’s a radical new way to vape with a squonk RDA! The Innokin LIFTBOX Bastion Mod comes with a built-in, 8ml syphon tank that automatically feeds e liquid up into your own squonking RDA. Although it has the cool look of a mechanical squonking box, the LIFTBOX Bastion mod has a basic control chip with three essential vaping safety features. This revolutionary Innokin syphon mod runs on a single 18650 battery (not supplied).
The first question to ask is, “will my squonk RDA fit on the Bastion mod’s 510 connector”? The LIFTBOX mod measures 82.6mm tall x 50.8mm long x 25.4mm wide. This means that squonk dripping atomizers up to 25mm in diameter will fit on top of the LIFTBOX mod without overhang.
When your LIFTBOX Bastion mod is delivered, you’ll see that the 510 connector is protected by a screw-down cap. The cap prevents gunge from falling into the glass e juice tank when there isn’t a squonk RDA connected. With the top-cap removed, there’s plenty of space available to fill the tank with 8ml of e liquid. The LIFTBOX mod’s removable front panel has a rectangular cut-out offering a clear view of your e liquid level.
For the special LIFT syphon tank to work, a bottom-feed squonk pin is essential on your RDA. The syphon tank actually uses internal air pressure to force e liquid up through the squonk pin, into your RDA’s build-deck.
With the LIFT tank filled, simply connect your bottom-feed, squonking RDA with the atomizer’s airflow set to the closed position. Before switching on the LIFTBOX Bastion mod, take a few draws from your RDA – this will set-up the air pressure required to feed e juice up into the build deck. At this point, you’ll need to play with a combination of RDA and LIFT tank airflow settings until you see that your coil wicks are being continuously saturated with each draw.
When you’re ready to vape, three clicks on the stylish Fire bar will activate the LIFTBOX mod. Along with built-in atomizer short circuit and battery protection capability, the LIFTBOX also has a USB battery charging facility. A bright LED on the Fire bar uses traffic-light colours to indicate the charge status of the single 18650 battery. This is a direct output device that feeds full remaining battery power to a connected squonking RDA.
With clean, fashionable design and an authentic carbon-fibre panel on the rear, Innokin’s LIFTBOX Bastion mod can be ordered with a Black, Orange, Red, Grey, or Green front panel.
Note: This advanced RDTA kit doesn’t come with a 18650 battery, squonk RDA or e liquid. Visit our Accessories pages, or click here to order a quality, low-cost battery and a squonk RDA. We also have a superb range of dripper-friendly e juices in our E Liquids pages
Contents:
1 x Innokin LIFTBOX Bastion Box Mod
1 x Battery Charge Cable (Mini USB)
1 x LIFTBOX Bastion Quick Start Guide
Innokin LIFTBOX Bastion Box Mod Features:
Size: 82.6mm tall, 50.8mm long, 25.4mm wide
Internal LIFT syphon tank capacity: 8ml
Comes with 3 adjustable syphonic airflow settings
Metallic parts: Aluminium
Tank: Reinforced glass
Will take squonk RDA’s up to 25mm diameter without overhang
Squonk RDA not included
Tank connection: Special LIFT 510 bottom feed tank connector
Style: Mid power, direct output mod with built-in syphon e liquid feed system
Operating mode: Direct output – remaining battery voltage applied to RDA
Cool logo and tank viewing window on front panel
Authentic carbon fibre panel on rear
Batteries: Requires 1 x 18650 battery (not included)
Removable, magnetic front panel for access to battery
Comes with plastic 510 stopper to protect tank
On-board USB charging facility
Simple LED battery status indicator, Green, Orange, Red
Comes with a mini USB charging cable
Long, stylish Fire bar
Compatible coil resistances: 0.1 to 3.5 Ohms
Max output current: 35 Amps
Voltage output: 3.3 to 4.2 Volts
Atomizer short-circuit cut-out for coil resistances below 0.08 Ohms
Battery low voltage & reverse polarity protection
High-capacity tank for lots of vaping between refills
Superbly well manufactured
5 fashionable front panel colours: a Black, Orange, Grey, Red, or Green
LIFTBOX Bastion Box Mod Compatibility:
This syphon box mod is recommended for experienced vapers. The mod will power squonk (bottom feed) RDA’s with mid-power DIY coil setups. To avoid overhang, dripping atomizers should have a diameter of 25mm or less. DIY coil builds should be between 0.1 and 3.5 Ohms.
Warranty:
For warranty information see our terms & conditions page.
We only ship orders to UK and operate a Same Day Dispatch (99% of the time, sometimes delays may occur) on all orders placed before 4pm on working days (Monday to Friday excluding weekends & Bank Holidays). Any orders placed after 4pm cut off on weekdays (Monday to Friday) or over weekends, will be dispatched the next WORKING day. We do not dispatch goods over weekends or bank holidays and do not offer delivery on Bank Holidays.
When you place an order, we will estimate a delivery date for you based on the shipping method you have chosen. This is an estimation only and is not guaranteed delivery date. All orders are shipped in discreet packaging.
You may return most new unopened items (excluding e liquids) within 14 days of delivery for a full refund excluding our postage costs we have incurred. We'll also pay the return shipping costs if the return is a result of our error (you received an incorrect item etc.). If the item is reported as defective, we will check item for issue/fault before deeming it faulty.
You should expect to receive your refund within 7 working days of the return arriving with us and being deemed faulty, however, in many cases you will receive a refund more quickly. This time period includes the product testing and the time it takes your bank to process our refund request (3 to 5 working days).
If you need to return an item, please Contact Us with your order number and details about the product you would like to return. We will respond quickly with instructions for how to return items from your order.
I really enjoy this mod and as I’m still new to vaping (less than 2 months in) this mod is used for my first RDA build